Hi,
I am designing "High data rate logger" and planning to interface High speed ADC which has parallel 14-bit outputs to EFM-02 and Store these samples in SSD that has USB 3.0 interface. I read in the specification of EFM-02 Spartan-6LX FPGA module with USB 3.0 provides transfer rate upto 300 MB/s. Also the SSD I'm using has 380MB/s write speed according to its specification.
My doubts are:
Is it possible to interface SSD to EFM-02 board and store the samples at 300MB/s?
How is the SSD accessed from FPGA through USB 3.0?
Do cesys provide an USB 3.0 device controller IP block for that?
Thanks and Regards,
Ramya S.
I am designing "High data rate logger" and planning to interface High speed ADC which has parallel 14-bit outputs to EFM-02 and Store these samples in SSD that has USB 3.0 interface. I read in the specification of EFM-02 Spartan-6LX FPGA module with USB 3.0 provides transfer rate upto 300 MB/s. Also the SSD I'm using has 380MB/s write speed according to its specification.
My doubts are:
Is it possible to interface SSD to EFM-02 board and store the samples at 300MB/s?
How is the SSD accessed from FPGA through USB 3.0?
Do cesys provide an USB 3.0 device controller IP block for that?
Thanks and Regards,
Ramya S.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von ramya ()