Cesys support Forum for FPGA boards and CEBO DAQ

Cesys customer support and general FPGA discussions

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

Recent Activities

  • maradim -

    Replied to the thread EFM03 AXI-FX3 GPIO register Address.

    Post
    Hello Simon, I assume you mean our user guide "UG121 - AXI-FX3-Interface v1.2" by datasheet. Our EFM-03 reference design is based on the AXI bus. The address ranges of the page 19 table mean AXI bus ranges of AXI slaves, and these addresses are byte…
  • Simon.Reiger -

    Posted the thread EFM03 AXI-FX3 GPIO register Address.

    Thread
    Hello! I'm pretty new to this, so please forgive any obvious questions. Considering the Address Range of the AXI-FX3 interconnect: The following map is from the Datasheet (p.19): * * Name * Interf * Start Addr. * Range * End Addr. * GPIO 0…
  • maradim -

    Replied to the thread Maximum available Read Speed of EFM03 in MegaBytes per second.

    Post
    Hello Özgün, our UDK3 includes the UDK3 Performance monitor which can measure the transfer speed between host PC over USB3 to DDR3L RAM and back. I have measured 204 MBytes/s for read/write measurement and selected DDR3L as RAM on EFM-03 with a…
  • sopelvan -

    Replied to the thread Maximum available Read Speed of EFM03 in MegaBytes per second.

    Post
    Hello Manfred, Thanks for your reply. I think I was not clear on my question. What I wanted to learn was what was the configuration and highest rate that you achieved using the EFM03 board ? For example with the following computer configuration…
  • maradim -

    Replied to the thread Maximum available Read Speed of EFM03 in MegaBytes per second.

    Post
    Hello Özgün, the EFM-03 product page on our website cesys.com/en/our-products/fpga-boards/efm-03.html states 320 MByte/s as a possible maximum. This number is also stated in our EFM-03 hardware reference UG-120 v1.1 on page 2: