Hello there,
This is Dawei again. From page 10 of hardware reference, it mentions
So I tried it out on UDK3 Board Manager. However, I got the "Failure in control transfer" error, as attached. Any idea where I could be missing?
In addition, I tried to connect to FPGA JTAG directly through J13 on evaluation board, with Digilent HS2 programming cable. But it was not able to identify the Xilinx FPGA.
FYI - This EFM-03 is powered on USB bus, with the red jumper J5 on, and I saw a green LED on. I also measured the core FPGA voltage, which is 1.0V. So it means the on board regulators should be working.
Any suggestion would be appreciated.
Thanks,
Dawei
This is Dawei again. From page 10 of hardware reference, it mentions
"To help the system designer to successfully implement a Artix-7 design some crucial peripherals are installed onboard, with a VHDL reference design 'efm03_wrapper' readily available"
So I tried it out on UDK3 Board Manager. However, I got the "Failure in control transfer" error, as attached. Any idea where I could be missing?
In addition, I tried to connect to FPGA JTAG directly through J13 on evaluation board, with Digilent HS2 programming cable. But it was not able to identify the Xilinx FPGA.
FYI - This EFM-03 is powered on USB bus, with the red jumper J5 on, and I saw a green LED on. I also measured the core FPGA voltage, which is 1.0V. So it means the on board regulators should be working.
Any suggestion would be appreciated.
Thanks,
Dawei