Hello,
please could someone give me any suggestion to eliminate the following driver error?
The working condition is: we are using a hub between the card and the pc to be able to use two USB3FPGA cards
If I remove the hub the error disappears.
Thanks
Claudio
please could someone give me any suggestion to eliminate the following driver error?
Quellcode
- Try to access device : /dev/ceusb0
- Added : /dev/ceusb0
- Try to open device: /dev/ceusb0
- Firmware flag is true
- Try to access device : /dev/ceusb0
- Added : /dev/ceusb0
- 1 devices detected.Good Init!
- Try to open device: /dev/ceusb0
- Exception occured:
- Code: 0x80001003Description: USB control message failed ! (caused in <VendorCmd> (device.cpp:212))
The working condition is: we are using a hub between the card and the pc to be able to use two USB3FPGA cards
If I remove the hub the error disappears.
Thanks
Claudio